6/30/2023 0 Comments Att uverse no signal on tv![]() The recording conflict could not be cleared This will temporarily disrupt internet, TV, and Voice service. If that doesn't solve the problem, unplug your Wi-Fi gateway and wait two minutes, then plug it back in and restart. Try unplugging your receiver and waiting two minutes, plugging it back in, and then restarting. ![]() If these screens display, your system is having trouble communicating. Red X, Client Initialization Error, or Diagnostic Info Screen displayed This screen should display for several seconds, followed by a blank screen displayed for several minutes as the process continues. If you see three dots on your screen, it means your system is connecting. Unplug your receiver and wait five minutes, plug it back in, and then restart. If the lights on your U-verse receiver are blinking and no TV picture is displayed, your receiver is having trouble coming online. ![]() If you're seeing the icon for more than an hour, unplug the receiver and wait five minutes, plug it back in, and then restart.īlinking lights on the receiver with no TV picture Most downloads finish in less than an hour. Restart each receiver by pressing and holding the Power button for 10 seconds.If you see the gear or cog icon on your screen, it means that software is downloading to your system.If you replaced your WAP, you’ll need to pair any existing, wireless receivers with the new WAP. Pair existing wireless receivers with a new WAP It may take a few minutes for live TV to appear. When you see a green LED lit on the front of the receiver, you’ve paired successfully. Confirm that at least three LED green bars are lit on the wireless receiver.On the front of your wireless receiver, press the OK button within two minutes.Pair a new wireless receiver with an existing WAP Return to the Set up and pair your wireless receiver and WAP section of this solution and follow the instructions to connect your WAP, connect your wireless receiver, and pair the two. TV receiver and/or WAP lights not appearing You’ll need to select a different location. If the connection error reappears after repeating steps 2 - 6, the location is out of wireless range.Following a successful pairing, unplug the wireless TV receiver and reconnect it at the desired location. ![]() After two minutes, the Link light on the front of the wireless TV receiver should be solid green. Wait two minutes for the receiver and WAP to pair.Press the OK button on the front of the wireless TV receiver.Wait one minute for the receiver software to load.Disconnect your wireless receiver from the original location and reconnect the power cord at a location closer to the WAP.If you’re having more specific issues, try the troubleshooting steps below. Move the receiver closer to the WAP (to determine if the problem is a distance issue).Power cycle the WAP by unplugging the WAP from the electrical outlet for 10 seconds and then plugging it back in.If no lights are on, ensure that the TV receiver is turned on by pressing and releasing the AT&T button on the remote control, and then pressing and holding the Power button on the receiver for 10 seconds.If you do not have power, move the TV receiver to a working electrical outlet. If you have power and the TV receiver is turned on, the power button on the front of the receiver has a green light surrounding it. Many wireless receiver problems can be solved by checking your connections, power, and signal strength.Įnsure all cables and cords are connected properly and securely. ![]()
0 Comments
Leave a Reply. |